fbpx
  Friday, 23 October 2020
  0 Replies
  2.7K Visits
0
Votes
Undo
  Subscribe
UPDATE: I figured it out! After days of reading and not understanding Roland's documentation and searching online, I finally figured out how to assign the A-800 Pro's sliders to control the VR-09B's lower manual drawbars via SysEx! In case anyone else is wondering, my SysEx messages are as follows: F0 41 10 62 12 SS 02 01 0_ DT S1 F7 (substitute _ with offsets 3 - B for each respective drawbar). And below is a breakdown of each byte in case anyone is wondering:

F0 - Exclusive status
41 - Roland's manufacturer ID
10 - Roland's default device ID
62 - Model ID
12 - Command ID: DT1; transfer data
SS - Checksum insertion (A-Pro Editor feature; omit entirely if using another program)
02 - Start address pt. 1: Organ lower
01 - Start address pt. 2: Organ lower
0_ - Address offsets: 3, 4, 5, 6, 7, 8, 9, A, B
DT - Data insertion (A-Pro Editor feature; otherwise manually input each data byte from 08 - 00)
S1 - Checksum insertion (A-Pro Editor feature; otherwise manually input each checksum)
F7 - EOX

If you are using A-Pro Editor, set 'Min Value' to 8 and 'Max Value' to 0 to create the "pull down to increase" effect of real drawbars.

This was actually my first MIDI implementation project ever and I'm now excited to see what more I can learn and do with it in the future!
____________________________________________________________________________________________________________

Hey, all. Hammond B3 enthusiast and total MIDI noob here. So I have a VR-09B V-combo organ and an A-800 Pro MIDI keyboard (with 9 sliders), both Roland products. I also have two MIDI cables. I would like to do a split mode where the A-800 Pro keyboard acts as a lower manual AND its sliders act as lower manual drawbars, while keeping upper manual on the VR-09B itself.
According to Roland support, this should be possible using system exclusive messages. Does anybody have any idea on how this could be achieved? I'll try to share all I know that may help:

  • The start address for the organ lower part is 02 01 00, and for the upper part is 02 00 00.
  • The 9 drawbar offsets go in ascending order, from 00 03 to 00 0B.
  • SOLVED: Each drawbar has a value range of 0 to 8. I'd also like to slide it down to increase the value and up to decrease, much like actual organ drawbars.
  • This one might be a bit of a stretch, but if I could get those drumpads on the A-800 Pro to control drum sounds on the VR-09B while also still performing the above, that would be amazing!

Thanks in advance to anyone who's able to help me.
There are no replies made for this post yet.
Be one of the first to reply to this post!