Lately i started working with a good old synth rack, the crumar bit 01.
I found out that there is third party support for cc implementation with hardware firmware update, but i also realised that there is some kind of sysex implementation too.
The bit 99 ( the same synth with a keyboard) manual is quite clear, but for an inexperienced sysex user like me, not so.
So i’m asking you experts, if by following the data from pages 30 - 34 of the manual, i am correct to assume that for a setting of 10 on the LFO 1 depth parameter, the appropriate sysex message is :
F0 25 01 01 02 11 00 10 F7
Where am i wrong? Where am i right?
F0 is used as start of message ,
25 as manufacturer nr,
01 as model nr,
01 as device nr,
02 as parameter byte,
11 as parameter command,
00 as lsb,
10 as msb,
F7 as end of message.
If you have the time to check the related manual’s pages please advice. Any further advice is more than welcome.
Thanks in advance