The MIDI Forum

  1. Carlos
  2. MIDI Software
  3. Tuesday, 07 June 2016
  4.  Subscribe via email
Good day,

Would anyone know the MIDI SysEx message necessary to change banks in an Eventide H3500-DFX?

The pdf manual available on the net shows a SysEx message on page 34 (F0 7F nn 02 01 0c 00 00 00 00 0b 00 F7), but it doesn't work.

The H3500-DFX is the top-of-the-line unit of the original Eventide H3000 series.

Thank you
Comment
There are no comments made yet.
Accepted Answer Pending Moderation
0
Votes
Undo
I found the answer: the SysEx message works!

On the message, nn = the device ID, c = the MIDI channel, b = the bank number.

The MIDI channel settings are 00 to 15 for channels 1 to 16.

The base channel of the H3500 was set to 4. By setting up the channel on the message (c) to 3, it worked.

It is not necessary to turn the Sequencer function On for it to work.

A second message in Program Change (MIDI channel, PC #) has to be entered as well. Once these two messages are programmed on the MIDI controller, the H3500 will switch presets in between banks with no problems.

Hope this helps other users!
Comment
There are no comments made yet.
  1. more than a month ago
  2. MIDI Software
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!