The MIDI Forum

  1. Karim
  2. MIDI Software
  3. Monday, 18 February 2019
  4.  Subscribe via email
Is there a specific rule in how the Running Status for a Control Change should be implemented?

For example, I want to send volume control to Ch1, B0 07 10 07 08? Or are there specific control changes i.e RPN or any Bn (number) that allow Running Status?

I appreciate any help.
Comment
There are no comments made yet.
Accepted Answer Pending Moderation
0
Votes
Undo
Running status can be used with any message that has a status byte that contains a channel (status bytes 80 to EF). If you want to send two or more sequential messages that would have the same status byte, you can omit the status byte from the second and later messages.

You can download the main MIDI specification as a PDF file from the following page on this site: Specs -> The MIDI 1.0 Specification -> The Complete MIDI 1.0 Detailed Specification. (You have to log in with your account to download the PDF file.) Running Status is described on PDF pages 91 to 93.
Comment
There are no comments made yet.
  1. 4 weeks ago
  2. MIDI Software
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.