The MIDI Forum

0
Votes
Undo
  1. Steffan
  2. MIDI Software
  3. Saturday, 21 September 2019
  4.  Subscribe via email
MIDI Expression commands:
MSB 0x0B
LSB 0x2B

Does it matter which one is send first? MSB or LSB
Comment
There are no comments made yet.
Accepted Answer
Accepted Answer Pending Moderation
0
Votes
Undo
In many cases, only MSB messages are sent. Therefore, many synthesizers reset the LSB when the MSB is received. Therefore, you should send the MSB first.

It is possible to send only the LSB if the MSB has not changed.
Comment
There are no comments made yet.
Accepted Answer Pending Moderation
0
Votes
Undo
Yes, it matters.
What are the full MIDI messages you are using?
Comment
There are no comments made yet.
  1. 3 weeks ago
  2. MIDI Software
  3. # 1
Accepted Answer Pending Moderation
0
Votes
Undo
Thank you for your response Eddie.
I want to stream (continuously) a 14 bit Expression message.
But I was not sure if there is a specific order,
considering the messages are very specific about their function/purpose.

I basically wrote my drivers to look like this:

Send_MIDI_Message(Control_Change, Channel, 0x2B, TempExprsLo);
Send_MIDI_Message(Control_Change, Channel, 0x0B, TempExprsHi);
Comment
There are no comments made yet.
  1. 3 weeks ago
  2. MIDI Software
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!