The MIDI Forum

Resolved midi din 4 and 5

0
Votes
Undo
  1. michaël
  2. MIDI Specifications
  3. Wednesday, 11 December 2019
  4.  Subscribe via email
i search on paper... :

on midi din, there are two ouput voltages or juts one (i see this in a next time...) on midi din 4 and 5.

i understand probably interst of din 5 (uart, data midi), but :

what's object or intrest for din 4 ? there are no uart on this, is it only an electricity alimentation for the receiver with no data ?

thanks
Comment
There are no comments made yet.
Accepted Answer Pending Moderation
0
Votes
Undo
The shield (connected to pin 2 at the sender) blocks electrical noise.

The current goes from pin 4 to pin 5. To transmit a 0 bit, the sender pulls pin 5 low. To transmit a 1 bit, the sender pulls pin 5 high, or leaves it open.
Comment
There are no comments made yet.
  1. more than a month ago
  2. MIDI Specifications
  3. # 1
Accepted Answer Pending Moderation
0
Votes
Undo
what's use of pin 2 ? shield... security if midi cable is broken.

current loop goes to pin 5 to 4 ?

but on this link, are there are a mistake ? because diode stop the current to pin 4 :

https://cdn.sparkfun.com/assets/learn_tutorials/4/0/8/signaling-one.png

thanks
Comment
There are no comments made yet.
  1. more than a month ago
  2. MIDI Specifications
  3. # 2
Accepted Answer Pending Moderation
0
Votes
Undo
MIDI uses a current loop (mark = 0 mA, space = 5 mA). Two pins are needed to drive the required current through the receiver's IR LED. The three resistors (two in the sender, one in the receiver) are needed to limit the current to 5 mA; the resistors are distributed this way to make the connectors short-circuit tolerant.

The actual voltages at pins 4 and 5 are not really important. (However, some cheap interfaces omit the optoisolator and just measure the voltage at pin 5; in that case, pin 4 is not needed.)
Comment
There are no comments made yet.
  1. more than a month ago
  2. MIDI Specifications
  3. # 3
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!