The MIDI Forum

  1. Jimmy
  2. Getting Started with MIDI
  3. Saturday, 17 June 2017
  4.  Subscribe via email
Might be an odd request I know. I have an old Roland SC-55 and I need to be able to change part via midi to actually see the adjustments I make on the SC-55 screen... For example, if part 1 is on the -55's screen and make adjustments to part 1, via midi. I can see the changes on the display. However I I then want to make changes to part 2, I can make the changes ok but I don't have the reassurance of seeing the changes as the happen, unless I go over to the 55 and use the button to change the part on the display... Anyone any ideas?

Jimmy
Comment
There are no comments made yet.
Clemens Ladisch Accepted Answer Pending Moderation
0
Votes
Undo
You could give your entire setup a title (which replaces the default "–SOUND Canvas–";), or display a 16×16 pixel graphic (see p. 78 of the manual). But there is no other mechanism to affect what is shown on the display.

Apparently, parameters should be heard and not seen. :)
Comment
There are no comments made yet.
  1. more than a month ago
  2. Getting Started with MIDI
  3. # 1
Jimmy Accepted Answer Pending Moderation
0
Votes
Undo
Thanks Clemens Ladisch... I was afraid that was the case

The frustrating thing is, it seems all the other parameters on the display can be visually changed remotely via midi, as long as I get up and switch the part by hand.
Maybe I'll checkout ebay for an actual remote control

Jim
Comment
There are no comments made yet.
  1. more than a month ago
  2. Getting Started with MIDI
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.