The MIDI Forum

  1. frank
  2. Getting Started with MIDI
  3. Wednesday, 12 July 2017
  4.  Subscribe via email
Hi,

I bought "Arturia BeatStep Controller/Sequencer"

https://www.amazon.co.uk/dp/B00I88HPUO/ref=pe_1909131_77697121_tnp_email_TE_AMZLdp_1

I have a simple C++ program running on a PC that writes to command line received MIDI messages when rotating a knob/endless encoder(EE).
https://www.music.mcgill.ca/~gary/rtmidi/index.html#input

Values from EE are in 1 step increment from 0 to 127 (If I rotate the EE after it reached 127 or 0 it never get above 127 or below 0)

Is it possible to control/set the value of the EE from PC ? I mean, when I spin the EE to e.g. value 127 on the MIDI controller can I set its value to e.g. 0 with a MIDI message sent prom the PC ?
What would the MIDI message look like ?

Thank you !
Frank
Comment
There are no comments made yet.
Clemens Ladisch Accepted Answer Pending Moderation
0
Votes
Undo
There is software that allows to configure the controls, but there does not appear to be any official documentation about what messages it uses.

But there is Taming Arturia’s Beatstep: Sysex codes for programming. In the comments, somebody mentioned a SysEx that works on the BeatStep Pro.
Comment
There are no comments made yet.
  1. more than a month ago
  2. Getting Started with MIDI
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.